Я установил три Intel X540-T1 на серверах под управлением Ubuntu Server 12.04, но все они не работают, нет индикаторов ссылок, нет отправленных и полученных пакетов, а также нет соединения на ip4 или ip6, независимо от того, настроено ли оно как dhcp или статическое. Кроме того, dmesg не определяет подключение или отключение кабеля.
Я обновил драйвер ixgbe по умолчанию до последней версии Intel (3.11.33) без изменений. Контроллер Ethernet сообщается как X540-AT2 (что может быть проблемой, которую я не могу понять, как исправить), но подсистема - X540-T1, поэтому я считаю, что это могло быть предназначено.
У кого-нибудь есть опыт в этом, который мог бы помочь?
ifconfig eth2
eth2 Link encap:Ethernet HWaddr a0:36:9f:14:5f:ea
inet addr:192.168.101.1 Bcast:192.168.101.255 Mask:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1<br>
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
ethtool -i eth2
driver: ixgbe
version: 3.11.33
firmware-version: 0x8000037c
bus-info: 0000:08:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
lspci -vvnns 08:00.0
08:00.0 Ethernet controller [0200]: Intel Corporation Ethernet Controller 10 Gigabit X540-AT2 [8086:1528] (rev 01)
Subsystem: Intel Corporation Ethernet Converged Network Adapter X540-T1 [8086:0002]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr+ Stepping- SERR+ FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 16
Region 0: Memory at e8000000 (64-bit, prefetchable) [size=2M]
Region 4: Memory at e8200000 (64-bit, prefetchable) [size=16K]
[virtual] Expansion ROM at e8280000 [disabled] [size=512K]
Capabilities: <access denied>
Kernel driver in use: ixgbe
Kernel modules: ixgbe
Отредактируйте вывод dmesg:
dmesg | grep ixgbe
[ 1.684782] ixgbe 0000:08:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[ 1.684800] ixgbe 0000:08:00.0: setting latency timer to 64
[ 1.685138] ixgbe: 0000:08:00.0: ixgbe_check_options: FCoE Offload feature enabled
[ 2.068069] ixgbe 0000:08:00.0: irq 45 for MSI/MSI-X
[ 2.068075] ixgbe 0000:08:00.0: irq 46 for MSI/MSI-X
[ 2.068079] ixgbe 0000:08:00.0: irq 47 for MSI/MSI-X
[ 2.429029] ixgbe 0000:08:00.0: (PCI Express:2.5GT/s:Width x8) a0:36:9f:14:5f:ea
[ 2.620029] ixgbe 0000:08:00.0: eth2: MAC: 3, PHY: 3, PBA No: G54042-004
[ 2.620033] ixgbe 0000:08:00.0: eth2: Enabled Features: RxQ: 2 TxQ: 2 FdirHash RSC
[ 2.652184] ixgbe 0000:08:00.0: eth2: Intel(R) 10 Gigabit Network Connection
[ 2.652237] ixgbe 0000:10:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[ 2.652254] ixgbe 0000:10:00.0: setting latency timer to 64
[ 2.652566] ixgbe: 0000:10:00.0: ixgbe_check_options: FCoE Offload feature enabled
[ 3.032057] ixgbe 0000:10:00.0: irq 48 for MSI/MSI-X
[ 3.032062] ixgbe 0000:10:00.0: irq 49 for MSI/MSI-X
[ 3.032067] ixgbe 0000:10:00.0: irq 50 for MSI/MSI-X
[ 3.393034] ixgbe 0000:10:00.0: (PCI Express:2.5GT/s:Width x8) a0:36:9f:10:a8:f2
[ 3.584019] ixgbe 0000:10:00.0: eth3: MAC: 3, PHY: 3, PBA No: G54042-004
[ 3.584023] ixgbe 0000:10:00.0: eth3: Enabled Features: RxQ: 2 TxQ: 2 FdirHash RSC
[ 3.616178] ixgbe 0000:10:00.0: eth3: Intel(R) 10 Gigabit Network Connection
Редактировать вывод sudo lspci
sudo lspci -vvnns 08:00.0
08:00.0 Ethernet controller [0200]: Intel Corporation Ethernet Controller 10 Gigabit X540-AT2 [8086:1528] (rev 01)
Subsystem: Intel Corporation Ethernet Converged Network Adapter X540-T1 [8086:0002]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr+ Stepping- SERR+ FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 16
Region 0: Memory at e8000000 (64-bit, prefetchable) [size=2M]
Region 4: Memory at e8200000 (64-bit, prefetchable) [size=16K]
[virtual] Expansion ROM at e8280000 [disabled] [size=512K]
Capabilities: [40] Power Management version 3
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold-)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [50] MSI: Enable- Count=1/1 Maskable+ 64bit+
Address: 0000000000000000 Data: 0000
Masking: 00000000 Pending: 00000000
Capabilities: [70] MSI-X: Enable+ Count=64 Masked-
Vector table: BAR=4 offset=00000000
PBA: BAR=4 offset=00002000
Capabilities: [a0] Express (v2) Endpoint, MSI 00
DevCap: MaxPayload 512 bytes, PhantFunc 0, Latency L0s <512ns, L1 <64us
ExtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset+
DevCtl: Report errors: Correctable+ Non-Fatal+ Fatal+ Unsupported+
RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop+ FLReset-
MaxPayload 128 bytes, MaxReadReq 512 bytes
DevSta: CorrErr+ UncorrErr- FatalErr- UnsuppReq+ AuxPwr- TransPend-
LnkCap: Port #0, Speed 5GT/s, Width x8, ASPM L0s L1, Latency L0 <512ns, L1 <4us
ClockPM- Surprise- LLActRep- BwNot-
LnkCtl: ASPM Disabled; RCB 64 bytes Disabled- Retrain- CommClk+
ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
LnkSta: Speed 2.5GT/s, Width x8, TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt-
DevCap2: Completion Timeout: Range ABCD, TimeoutDis+
DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-
LnkCtl2: Target Link Speed: 5GT/s, EnterCompliance- SpeedDis-, Selectable De-emphasis: -6dB
Transmit Margin: Normal Operating Range, EnterModifiedCompliance- ComplianceSOS-
Compliance De-emphasis: -6dB
LnkSta2: Current De-emphasis Level: -6dB
Capabilities: [100 v2] Advanced Error Reporting
UESta: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
UEMsk: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq+ ACSViol-
UESvrt: DLP+ SDES+ TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt- RxOF+ MalfTLP+ ECRC- UnsupReq- ACSViol-
CESta: RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr+
CEMsk: RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr+
AERCap: First Error Pointer: 00, GenCap+ CGenEn- ChkCap+ ChkEn-
Capabilities: [140 v1] Device Serial Number a0-36-9f-ff-ff-14-5f-ea
Capabilities: [150 v1] Alternative Routing-ID Interpretation (ARI)
ARICap: MFVC- ACS-, Next Function: 0
ARICtl: MFVC- ACS-, Function Group: 0
Capabilities: [160 v1] Single Root I/O Virtualization (SR-IOV)
IOVCap: Migration-, Interrupt Message Number: 000
IOVCtl: Enable- Migration- Interrupt- MSE- ARIHierarchy-
IOVSta: Migration-
Initial VFs: 64, Total VFs: 64, Number of VFs: 64, Function Dependency Link: 00
VF offset: 384, stride: 2, Device ID: 1515
Supported Page Size: 00000553, System Page Size: 00000001
Region 0: Memory at 00000000c0e00000 (64-bit, non-prefetchable)
Region 3: Memory at 00000000c0d00000 (64-bit, non-prefetchable)
VF Migration: offset: 00000000, BIR: 0
Capabilities: [1d0 v1] Access Control Services
ACSCap: SrcValid- TransBlk- ReqRedir- CmpltRedir- UpstreamFwd- EgressCtrl- DirectTrans-
ACSCtl: SrcValid- TransBlk- ReqRedir- CmpltRedir- UpstreamFwd- EgressCtrl- DirectTrans-
Kernel driver in use: ixgbe
Kernel modules: ixgbe
Оказывается, что прототипные сетевые адаптеры не будут напрямую взаимодействовать с какими-либо другими сетевыми адаптерами. Я не уверен, почему именно. X540-T1 в Ubuntu отлично работают, разговаривая друг с другом, по крайней мере, после установки последних драйверов Intel (и, возможно, раньше). Спасибо всем за помощь.